There’s nothing like a warm indoor space to take the sting out of a blustery winter day, but there’s nothing worse than a heater that quits just when you need it most. Losing heat for any length of time can be inconvenient at best and dangerous at worst. Fortunately, when you partner with Cool Care Heating & Air, you can rest assured that whether you need emergency heating repair or annual furnace maintenance, we’ll go all out to keep you comfortable. Cool Care Heating & Air is a Bryant Factory Authorized Dealer, so you can always count on prompt service, a courteous attitude, reasonable prices and top-shelf products.
AC units and thermostats have built-in delay features when they’re shut down and then repowered. The delay can be as long as 10 minutes. And, if you’ve subscribed to an energy-saving device from your local power utility, the unit can take even longer to reset. If you’ve installed the parts shown and reinstalled the disconnect block, repowered the circuit breaker, turned on the switch at the furnace, moved the thermostat to AC mode and lowered the temperature below the indoor temperature, and the unit doesn’t fire up after 30 minutes, it’s time to call a pro.
High-efficiency condensing furnaces (90% AFUE and above) are a bit more complex than conventional furnaces. The main differences between a conventional and condensing furnace are the heat exchanger technology used to extract heat from the combustion process and the method used to exhaust the combustion gases. In these ways, the furnaces are very different. The condensing furnace does not have a significantly more efficient combustion process than does a conventional furnace; both use gas burners with electronic ignition. The difference lies in that the condensing furnace has a more efficient heat extraction process after combustion.
SEER is related to the coefficient of performance (COP) commonly used in thermodynamics and also to the Energy Efficiency Ratio (EER). The EER is the efficiency rating for the equipment at a particular pair of external and internal temperatures, while SEER is calculated over a whole range of external temperatures (i.e., the temperature distribution for the geographical location of the SEER test). SEER is unusual in that it is composed of an Imperial unit divided by an SI unit. The COP is a ratio with the same metric units of energy (joules) in both the numerator and denominator. They cancel out, leaving a dimensionless quantity. Formulas for the approximate conversion between SEER and EER or COP are available.
Multiple inventions within this time frame preceded the beginnings of first comfort air conditioning system, which was designed in 1902 by Alfred Wolff (Cooper, 2003) for the New York Stock Exchange, while Willis Carrier equipped the Sacketts-Wilhems Printing Company with the process AC unit the same year. Coyne College was the first school to offer HVAC training in 1899.
In addition to providing repairs for A/C and HVAC systems, we can also repair almost any heating system. Just tell us what the trouble is and we will run the appropriate tests and checks to find out what needs doing to get your heating operational again. We use high-grade equipment and tools for every job we complete, helping to give you the top-quality results you’re looking for.
Whether you’re confronted with a minor maintenance issue, safety concern, or system failure, don’t hesitate to call 303-678-5576 for expert assistance. 24/7 Emergency Service allows you to get the help you need, whenever you need it. For all repairs, we prioritize your best interests, providing the information, cost-effective recommendations, and honest answers that add up to greater value for your investment. Our experienced HVAC specialists are familiar with all makes and models, and focus on repairs that enhance the reliability and performance of your equipment. When the job is complete, rest assured there will be no mess, damage, or discarded debris for you to deal with, and your furnace will be ready to meet demand. At Welzig Heating & Air, we build on a reputation for excellence each time we answer a call for repair across Boulder, Longmont, Louisville, Lafayette, CO & more.
As a Carrier® dealer, with a wide variety of products to choose from, we can keep your family healthy and feeling comfortable all year long. We carry a complete line of indoor comfort equipment with innovations that raise the standards of comfort and reliability, including air conditioners, heat pumps, gas furnaces, programmable thermostats, humidifiers, ductless split systems, geothermal systems, boilers, air cleaners, ultra violet lights, ventilators and zoning products. Let the experts at Dunes Heating and Air Conditioning, LLC help you customize a solution that's right for you.
If you find yourself with a need today, don’t hesitate to contact us now. We want to prove to you why we have such stellar ratings for quality and customer satisfaction in Cary. To easily make an appointment, you can contact us on our website, chat online, or call us at 919-578-4329. With one conversation, we’ll show you why you can be comfortable and confident in your decision to work with us. Find out today what your friends and neighbors in Cary have already found: You can rely on Service Experts.
Concrete Blocks -- Concrete blocks are used in foundations and are often found in full basements. Insulating the spaces in the blocks is not the way to insulate them as the heat energy will travel along the concrete itself. The best way to insulate with concrete blocks is to use insulated concrete blocks, which have polystyrene incorporated into them.
Whether it’s AC repair or total AC system replacement, there are various terms within the HVAC industry that can get confusing for homeowners. Not to mention all of the different pieces of heating and air conditioning equipment that can be used to boost your home’s energy efficiency and air quality. Of course we can’t write about all of the variations in a short blog post, so we’ll take a look at one of the routine inquiries we see at Service Experts Heating & Air Conditioning: what’s the difference between an air conditioner and an air handler?